Hand-pulling dents to using a stud welder, what a game changer

Ngl, I used to do all my small dent pulls with a slide hammer and a prayer back in my first shop in Phoenix. Took me 20 minutes per panel and half the time I'd warp the metal worse than the original hit. About 3 years ago my mentor handed me a stud welder and said 'stop being stubborn.' Now I can knock out a fender dent in under 5 minutes with way less filler needed. The heat control is the real trick, I still mess up on thin metal sometimes. Anyone else made the switch and never looked back?

0 comments

0 Comments

No comments yet

Be the first to share your thoughts on this discussion.